04-29-2016, 04:01 AM
(04-29-2016, 01:12 AM)Gunsmithy Wrote: I also tried to use GParted and various other tools but got the same error, overlapping partitions.
Step 1: Check your new SD card with either H2testw or F3. If this succeeds then you're ready for the next step
Step 2: Grab the Phoenix Card image (not the DD version), grab Phoenix Card and follow exactly these instructions: Start the software as admin, use 'format to normal' first and then burn in startup mode. Phoenix Card will partition the card itself and you can use the whole capacity afterwards.
Step 3: Disconnect Ethernet on 1st boot (otherwise boot will stuck on Pine64 logo), use a PSU that is known to provide 5.1V @ 2A and be patient (1st boot might take up to 10 minutes, next boots are faster)