06-17-2020, 10:00 PM
I just picked up a Rock64, and wanted to put Arch Linux ARM on it to reuse setup scripts I wrote for another SBC that was already running it.
The instructions didn't work for me -- u-boot failed, I would assume because of the SD changes in the V3 revision. Research made it sound like mainline u-boot should work, but I didn't have any luck with it. master failed with a hang trying to access the SD card, and earlier revisions failed with a "Card did not respond to voltage select!" error.
Armbian did work, and I figured all I needed was really a working u-boot, so I bashed together the u-boot from Armbian with the root filesystem from Arch Linux ARM, and it booted!
I would still love to figure out what I was doing wrong with my u-boot builds (following the instructions from here: https://forum.pine64.org/showthread.php?tid=8174), but it seems like it's worked out. Assuming things don't burst into flames or anything.
For reference, this was the process that worked for me:
It's mostly the same as the basic install instructions: https://archlinuxarm.org/platforms/armv8...hip/rock64
The instructions didn't work for me -- u-boot failed, I would assume because of the SD changes in the V3 revision. Research made it sound like mainline u-boot should work, but I didn't have any luck with it. master failed with a hang trying to access the SD card, and earlier revisions failed with a "Card did not respond to voltage select!" error.
Armbian did work, and I figured all I needed was really a working u-boot, so I bashed together the u-boot from Armbian with the root filesystem from Arch Linux ARM, and it booted!
I would still love to figure out what I was doing wrong with my u-boot builds (following the instructions from here: https://forum.pine64.org/showthread.php?tid=8174), but it seems like it's worked out. Assuming things don't burst into flames or anything.
For reference, this was the process that worked for me:
It's mostly the same as the basic install instructions: https://archlinuxarm.org/platforms/armv8...hip/rock64
- In step 1, instead of zeroing out, I ran `dd if=/path/to/Armbian_bionic.img of=/dev/sdb bs=1M count=32`
- Steps 2-8 were unchanged
- Step 9 was skipped
- Steps 10-12 were unchanged
- Skipped updating u-boot through Arch
