03-01-2020, 09:52 AM
(This post was last modified: 03-02-2020, 01:24 PM by wdt.
Edit Reason: more
)
So, I think this means that uboot is not part of the image,
We have to pick whichever uboot (and idbloader, ATF) that we wish for the 1st 16M,,,
and since only one partition fdisk is easy
As to sleep, 5%/day is completely acceptable.
I think,IIRR strit on manjaro forum said S2 sleep needed 5.5.0-3-1 kernel (or better)
If this is the same as this, well I'll see
--edit--
Seems OK, I quickly change from gnome, I have a quite severe and visceral dislike
dd'd 16M /dev/zero, then 16M manjaro (1st 16) then fdisk, then dd ,, zcat ubuntu.img.gz|dd ............. blk1p1
It is sleeping now, until morning "wake up", to see how it will do
And, BTW automatically found printer, using driverless, a slightly different version of airprint/bonjour
--edit-- 12 hours later
so, no good for sleep, won't wake up,,, after a hard reset, used 50%+ power, 13hours
Bluetooth needs (perhaps) manjaro firmware
journalctl was no help at all re sleep, god do I hate systemd spaghetti
Oh yes, have to set xrender or screen goes transparent
We have to pick whichever uboot (and idbloader, ATF) that we wish for the 1st 16M,,,
and since only one partition fdisk is easy
As to sleep, 5%/day is completely acceptable.
I think,IIRR strit on manjaro forum said S2 sleep needed 5.5.0-3-1 kernel (or better)
If this is the same as this, well I'll see
--edit--
Seems OK, I quickly change from gnome, I have a quite severe and visceral dislike
dd'd 16M /dev/zero, then 16M manjaro (1st 16) then fdisk, then dd ,, zcat ubuntu.img.gz|dd ............. blk1p1
It is sleeping now, until morning "wake up", to see how it will do
And, BTW automatically found printer, using driverless, a slightly different version of airprint/bonjour
--edit-- 12 hours later
so, no good for sleep, won't wake up,,, after a hard reset, used 50%+ power, 13hours
Bluetooth needs (perhaps) manjaro firmware
journalctl was no help at all re sleep, god do I hate systemd spaghetti
Oh yes, have to set xrender or screen goes transparent