02-20-2020, 02:29 PM
Hi
I tried to disable EMC, no change... Except that the power led does not blink green now.
I measured on the battery. 4.16V DC between the red and black wires.
Nothing between the yellow and the black. What is the yellow wire?
Also, it does not boot when I connect the bypass cables.
Why is the bypass cable two wires (red and white) when they are soldered together on the main print.
IMG_0091c.jpg (Size: 361.21 KB / Downloads: 639)
IMG_0092c.jpg (Size: 340.3 KB / Downloads: 651)
Is that correct? Can someone confirm.
When the bypass cable is connected I cannot measure any voltage on the DC In test point (against e.g power in socket).
With bypass cable disconnected, the charging led blinks.
Any suggestions?
Best Regards
I tried to disable EMC, no change... Except that the power led does not blink green now.
I measured on the battery. 4.16V DC between the red and black wires.
Nothing between the yellow and the black. What is the yellow wire?
Also, it does not boot when I connect the bypass cables.
Why is the bypass cable two wires (red and white) when they are soldered together on the main print.
IMG_0091c.jpg (Size: 361.21 KB / Downloads: 639)
IMG_0092c.jpg (Size: 340.3 KB / Downloads: 651)
Is that correct? Can someone confirm.
When the bypass cable is connected I cannot measure any voltage on the DC In test point (against e.g power in socket).
With bypass cable disconnected, the charging led blinks.
Any suggestions?
Best Regards
