09-25-2018, 07:36 PM
(09-25-2018, 05:43 PM)jgpacc Wrote:(09-25-2018, 12:43 PM)Trash_Can_Man Wrote:Yes I am using OMV_4_Rock64. But I gave up on Etcher a while ago because I keep getting that "Couldn't clean the drive, Command Failed: diskpart /s" So I use DiskFormatter and Win32diskimager(09-25-2018, 11:47 AM)jgpacc Wrote: Thanks for your response. I tried the image you suggested but that wont even boot. I get what I would call stack dumps to the terminal. I can catch a few lines here and there talking about stack loop lockup bla bla CPU 3.
Stops for 90 seconds and starts again. I tried it on eMMC and SD card.
Going to see if I can reinstall the image I had working. Maybe the board gave up
Are you sure you downloaded the rock64 image? because it worked for me perfectly, what program do you use to write to SD card? i usually use etcher and works wonder, any other gives me mixed results but etcher works for me all the time...
I
Well anyway if your method works with the same image i linked and it boots and all but you have instability IMO the problem is somewhere else...your rock64 have at the very least a heatsink? your enclosures/adapters have UAS enabled? did you try to disable it? if you have tried all this im out of ideas...
