09-24-2018, 09:26 PM
I have been running a OMV on a HC1, XU4 and now Rock64. I decided to do performance comparisons. This then exposed my instability issue with Rock64. The HC1 gave 110 MB/s write speed. The XU4 only did 70 MB/s. The Rock64 might be the star I thought but it only did about 80 MB/s before it crashed. This now is the problem.
I try coping about 10 GBs from W10 to the Rock64 via ethernet and it fails every time at around 6 GBs. The box crashes and must be power cycled. There is no message in the OMV log. Smaller copies work and if I connect my USB 3.0 attached HDD to the USB 2 port the copy works but at 30 MB/s.
I have tried a HDD, a SSD and a M.2 SSD in a M.2 to USB enclosure. All 3 fail approximately the same. Makes me think the load is crashing something.
One error in the log I see occasionally is something like Fatal Watchdog not found.
I am running OMV 4.1.11 Linux version 4.4.132 on the eMMC. I have the correct power supply.
Anyone have any ideas on this problems? What other testing could I do to trap some meaningful error messages?
Thanks
Joep
I try coping about 10 GBs from W10 to the Rock64 via ethernet and it fails every time at around 6 GBs. The box crashes and must be power cycled. There is no message in the OMV log. Smaller copies work and if I connect my USB 3.0 attached HDD to the USB 2 port the copy works but at 30 MB/s.
I have tried a HDD, a SSD and a M.2 SSD in a M.2 to USB enclosure. All 3 fail approximately the same. Makes me think the load is crashing something.
One error in the log I see occasionally is something like Fatal Watchdog not found.
I am running OMV 4.1.11 Linux version 4.4.132 on the eMMC. I have the correct power supply.
Anyone have any ideas on this problems? What other testing could I do to trap some meaningful error messages?
Thanks
Joep
