06-29-2018, 04:19 AM
I was trying to install Grub to load Mint basically but I lost patience and now it is a mess.
More in details, I wanted to configure my pinebook to initiate the installation of Grub from a specific location.
But I did not know where to start. I discovered too late that it had no BIOS nor UEFI.
The actions I took were :
- attempt to partition an SD card to boot on Grub( partially failed)
- verify whether I had Synaptics, apturl or else (success)
- verify if Grub was installed (not installed)
- change from apturl to synaptic (success)
- verify the distribution (but I suspect the command has been forged to pretend it was Kali Linux)
- download boot-repair and Grub
- try to reboot holding shift/escape (fail)
- enter the commands that broke my installation
More in details, I wanted to configure my pinebook to initiate the installation of Grub from a specific location.
But I did not know where to start. I discovered too late that it had no BIOS nor UEFI.
The actions I took were :
- attempt to partition an SD card to boot on Grub( partially failed)
- verify whether I had Synaptics, apturl or else (success)
- verify if Grub was installed (not installed)
- change from apturl to synaptic (success)
- verify the distribution (but I suspect the command has been forged to pretend it was Kali Linux)
- download boot-repair and Grub
- try to reboot holding shift/escape (fail)
- enter the commands that broke my installation
