05-06-2018, 04:20 AM
On the RockPro64 Acrylic Open Enclosure page in the shop, there is this note : "Note: This case only fits ROCKPro64 board without PCIe interface card slot in.".
Is it safe to assume that the RockPrto64 Heatsink does fit this acrylic case ?
And just pushing my luck from here :
If the heatsink does not fit the case, could the top piece be marked with an almost invisible hairline square where the heatsink would have to go through (so that I/we could Dremel it) ?
Or better still a press-out square (although this might upset owners of other Pine boards).
Is it safe to assume that the RockPrto64 Heatsink does fit this acrylic case ?
And just pushing my luck from here :
If the heatsink does not fit the case, could the top piece be marked with an almost invisible hairline square where the heatsink would have to go through (so that I/we could Dremel it) ?
Or better still a press-out square (although this might upset owners of other Pine boards).
