04-20-2018, 08:46 PM
(01-23-2018, 10:58 AM)renatox Wrote:I have difficult time to figure out system code : 4040, is it HEX code or Decimal code? I assume it is HEX code as it specified beside key codes (in HEX). I did simulate this HEX code on arduino but not working. My rock64 setup as TV box. Can someone with pine64 A64 IR remote capture some logic raw data? I tried logitech harmony 650 and input pine64 as manufacture and rock64 as model number but still not working. Called logitech tech rep but no help. Can anyone help?(06-10-2016, 05:29 PM)tllim Wrote: The Android build already has the IR driver build in and should be work as is. Please make sure that you use the provided remote control and try out. If you plan to use Logitech Harmony, please program the IR command code that you can get on the Pine64 wiki page.
I have the codes, and the IR receiver as advised.
But there is no way to just have NEC code 4040 programmed in a harmony or a pronto.
It would help if the code was using a code that is from a standard device in the harmony or pronto catalog.
Is the remote the same as other remotes (adafruit..?)
