So that nobody can help so i will Share my uEnv.txt data here so anybody can assist with this.
The Pine dont show any screen, the screen appear with black background (with gamma and then without - after that the screen says no signal).
The Keyboard, which is connected to the Pine is on.
Used Image: android-7.1-pine-a64-tv-v0.3.5-r61
Used SD: SanDisk Ultra 32GB 98MB/sec (NEW)
Used Power Supplie (Original from Pine): 5V == 2A
Used Monitor(TV): Samsung Smart TV Full HD 58" with CEC support
Should I try another 0.3.5 image?
Is the TV image broken?
The Pine dont show any screen, the screen appear with black background (with gamma and then without - after that the screen says no signal).
The Keyboard, which is connected to the Pine is on.
Used Image: android-7.1-pine-a64-tv-v0.3.5-r61
Used SD: SanDisk Ultra 32GB 98MB/sec (NEW)
Used Power Supplie (Original from Pine): 5V == 2A
Used Monitor(TV): Samsung Smart TV Full HD 58" with CEC support
Should I try another 0.3.5 image?
Is the TV image broken?
Code:
console=ttyS0,115200n8
selinux=permissive
enforcing=0
optargs=no_console_suspend
kernel_filename=kernel
initrd_filename=ramdisk.img
recovery_initrd_filename=ramdisk-recovery.img
hardware=sun50iw1p1
# INFO:
# To enable one of below options,
# uncomment them by removing # in front of name
# To use android recovery:
# Create empty file recovery.txt in root of this partition
# To enable LCD or HDMI, if not changed it will use default (experimental)
disp_screen0=hdmi
# disp_screen1=lcd or hdmi
# disp_mode=screen0 or screen1 or dualhead or xinerama or clone
# USB OTG port mode (experimental)
# otg_mode=device or host or otg
otg_mode=host
# Configure contiguous memory allocation
# This maybe required to be enlarged for 4K displays
cma=384M
# To change HDMI display mode:
# hdmi_mode=480i
# hdmi_mode=576i
# hdmi_mode=480p
# hdmi_mode=576p
# hdmi_mode=720p50
# hdmi_mode=720p60
# hdmi_mode=1080i50
# hdmi_mode=1080i60
# hdmi_mode=1080p24
# hdmi_mode=1080p50
# hdmi_mode=1080p60
# hdmi_mode=2160p30
# hdmi_mode=2160p25
# hdmi_mode=2160p24
# To enable DVI compatibilty:
# disp_dvi_compat=on
# To enable CSI camera, if not enabled it will use default:
# camera_type=s5k4ec
# camera_type=ov5640
# Configure ethernet speed
eth0_speed=auto
# eth0_speed=1000
# eth0_speed=100
# eth0_speed=10
# Disable HDMI CEC
# hdmi_cec=0
# Enable experimental HDMI CEC driver
# hdmi_cec=2
