03-03-2016, 08:35 PM
ya my plan its quite the same but i'm going to use a USB charger to power the board and filter it with some caps! so i avoid noise 
to turn on/off the Display i'm going to use a service app that monitors the Accessory cable via a relay triggered to ground using one GPIO so
if is Undefined-state - OFF
if is LOW-State-On
and i'm going to use my nexus 7 battery to power the pine while is not powered by the car
in this way i avoid the battery drain
this is something what you had on mind.?
to turn on/off the Display i'm going to use a service app that monitors the Accessory cable via a relay triggered to ground using one GPIO so
if is Undefined-state - OFF
if is LOW-State-On
and i'm going to use my nexus 7 battery to power the pine while is not powered by the car
in this way i avoid the battery drain
this is something what you had on mind.?
By. Zoidiano0!
Installed:
LAMP: Linux , Apache2.4 , Mariadb, phpMyadmin, PHP5
Java 8 arm by oracle
Netbeans 8.1
chromium (uses way toooo much Ram)
Pine64 Head Unit Project.!
Installed:
LAMP: Linux , Apache2.4 , Mariadb, phpMyadmin, PHP5
Java 8 arm by oracle
Netbeans 8.1
chromium (uses way toooo much Ram)
Pine64 Head Unit Project.!
