Z-Wave module pinout to make it compatible with Pi b+

[j.hoekstra]

Strange. The Pine64 shop shows no adapter board:


(Nor do they show the antenna coil)

This is the previous version that using Mitsumi ZWave chip. Since Sigma Designs no longer selling the ZWave chip to Mistsumi, we force to use the Sigma Designs module.

But why bother with a removeable adapter board, why not solder the Z-wave chips directly on to the adapter? 

Can the Sigma module be used at all without the adapter?

We need to secure down this batch of boards which already have the build in adapter. If we order from Sigma Designs, the lead time is 16 weeks and there will be more complain about us fail to deliver. In long run, we will use the sigma module without the adapter.

Are you going to address the issues with case not usable when using zwave adapter and blocking the whole rpi-connector which prevents the board from working as advertised?
I wanted to use the IOT package as a complete controller incorporating emoncms, RF OOK and zwave in combination with openhab to control my home, which is now impossible. Are you going come up with a solution to make the package work as advertised?