Z-Wave module pinout to make it compatible with Pi b+

[MarkHaysHarris777]

Yeah, I think we just need some procedures for helping people fix things DIY fashion... for instance they also need to be warned that the ABS cases will not close if the z-wave module is installed on the board (did no one actually test these things )?

So, I'm telling people to remove the connector from the module and solder a ribbon cable between the connector and the module so that the module can be mounted off to the left away from handhold positions and the connector will fit on the board and the case will still shut.

I have not tried this either ( yet ) but rather than disabling the serial console, just move it to uart3 or uart4... I'll have to test that later and see if it works...