PINE64   ›   PINE A64(+)   ›   Pine A64 Hardware, Accessories and POT   ›   POT modules   ›   Z-Wave module pinout to make it compatible with Pi b+

Z-Wave module pinout to make it compatible with Pi b+
mdsutton
Pine Initiate
**
Joined: Jun 2016
Posts: 6

Reputation: 0
#23
09-07-2016, 07:53 AM (This post was last modified: 09-07-2016, 08:11 AM by mdsutton.)
The US version does not go on the EULER bus, it does on the pine bus, and makes the rest of bus useless, as well as the top of the case. A little disappointed in that.
Mark, you have to use the adapter board as it contains three Resistors and the inductor, so it is not just about laying the Z-wave board flat.
  Reply


Messages In This Thread
RE: Z-Wave module pinout to make it compatible with Pi b+ - by mdsutton - 09-07-2016, 07:53 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
Sad Z-Wave and openzwave+node-openzwave-shared saro 2 8,693 09-01-2017, 05:22 AM
Last Post: saro
  Z-Wave - Full and Low Power Inclusion mode B34N 1 6,085 03-26-2017, 06:03 PM
Last Post: B34N
  What cameras are compatible with that ribbon connector? nayrenitnatsnoc 1 5,576 02-18-2017, 11:50 PM
Last Post: dkryder
  KICAD Quick Lib and Module Generator mbt28 1 6,606 02-12-2017, 10:45 PM
Last Post: tllim
  Z Wave Module and still using GPIO bang 2 8,009 01-16-2017, 03:12 AM
Last Post: bang
  Z-Wave US module with adapter aegrotatio 4 10,364 01-08-2017, 12:03 AM
Last Post: aegrotatio
  RaZberry Module (z-wave) need support to get it working! Luxus 13 26,230 11-03-2016, 02:04 AM
Last Post: Luxus
  Z-Wave module problem vintagewaffle 0 3,267 10-26-2016, 10:50 AM
Last Post: vintagewaffle
  Raspberry Pi and Arduino accessories compatible? Krowyn 6 14,498 10-08-2016, 10:36 AM
Last Post: rohan
Video Australia/New Zealand Z-Wave module Jnimmo 46 79,715 10-02-2016, 02:25 PM
Last Post: tllim

Forum Jump:


Users browsing this thread: 1 Guest(s)