enble boot after power loss/restore
02-24-2022, 01:06 AM
(02-23-2022, 08:27 PM)Rocklobster Wrote:(02-23-2022, 03:41 PM)dkebler Wrote: Wanting the board to power when power is connected (i.e. after power is restored after power loss)
Hmmm.... I have a one RP64 that starts this way. I dug out my spare and it does not without hitting the power button.
Maybe there is a jumper that needs to be set. It was so long ago I set the first board up I can't remember and I don't see anything at the wiki that says to set a jumper for this.
Little help please.
Are both boards using identical setups. Same OS booting from SD card.
Have latest armbian on emmc but I don't think the module or os is the issue. As a test I pulled the emmc card. Then plug in power. Older unit (it's in a pine 64 NAS box with SATA card) powers (e.g. lights on ethernet port light, drives spin up, fans on). This new board (with nothing attached) doens't without pressing power and reset (at the same time, weird). Now put emmc back in. Exact same behavior
If it had a bios like an amd board it's just go into cmos and set this. But I just never remember having to set anything like this (jumper, something from serial interface) on R64Pro
