10-24-2021, 10:56 PM
(10-24-2021, 10:40 PM)KC9UDX Wrote: You should still have sound from the main speakers, just not from the headphone jack. Where did you get the cable? There are cables that are wrong and Pine64 even used to sell them. The correct one is 3.3V, the wrong one is 5V. It might be possible a wrong cable has RX and TX swapped, too.
Make sure your terminal is set for 1.500.000 baud. I know the first time I did it, I misread it as 150.000 baud.
I made a cable from old headphones and a Tigard tool switched to 3.3V, and I double checked the values with a meter. I think I had 1.5M baud set correctly, but I'll try again tomorrow.
Thanks for the clarification about the sound behavior, that wasn't obvious from what I had read!
