10-26-2016, 10:50 AM
(This post was last modified: 10-26-2016, 11:26 AM by vintagewaffle.)
So I have the US Z-Wave module (Sigma) version without an adapter.
Initially, it was working with the OpenHAB image from the wiki, but after adding the 4th device all devices stopped communicating.
I was getting some of them discovered as "Unknown Device" but once the module was reset completely they simply do not communicate at all.
I have tried using a different build with OpenHAB as well as built the OpenZWave console. In either case I have no problem communicating with the module and getting it initialized but No communication from the devices is received.
I see no communications error messages in the log either, I simply see no evidence of any communication from any device being received at all.
Is it possible the Z-Wave module itself is bad? I'm not sure how to test it at this point.
Any suggestions would be greatly appreciated.
Initially, it was working with the OpenHAB image from the wiki, but after adding the 4th device all devices stopped communicating.
I was getting some of them discovered as "Unknown Device" but once the module was reset completely they simply do not communicate at all.
I have tried using a different build with OpenHAB as well as built the OpenZWave console. In either case I have no problem communicating with the module and getting it initialized but No communication from the devices is received.
I see no communications error messages in the log either, I simply see no evidence of any communication from any device being received at all.
Is it possible the Z-Wave module itself is bad? I'm not sure how to test it at this point.
Any suggestions would be greatly appreciated.
