+- PINE64 (https://forum.pine64.org)
+-- Forum: PINE A64(+) (https://forum.pine64.org/forumdisplay.php?fid=4)
+--- Forum: Pine A64 Hardware, Accessories and POT (https://forum.pine64.org/forumdisplay.php?fid=32)
+---- Forum: POT modules (https://forum.pine64.org/forumdisplay.php?fid=8)
+---- Thread: Z-Wave module problem (/showthread.php?tid=2466)
Z-Wave module problem - vintagewaffle - 10-26-2016
So I have the US Z-Wave module (Sigma) version without an adapter.
Initially, it was working with the OpenHAB image from the wiki, but after adding the 4th device all devices stopped communicating.
I was getting some of them discovered as "Unknown Device" but once the module was reset completely they simply do not communicate at all.
I have tried using a different build with OpenHAB as well as built the OpenZWave console. In either case I have no problem communicating with the module and getting it initialized but No communication from the devices is received.
I see no communications error messages in the log either, I simply see no evidence of any communication from any device being received at all.
Is it possible the Z-Wave module itself is bad? I'm not sure how to test it at this point.
Any suggestions would be greatly appreciated.