09-23-2025, 09:25 PM
I just bought a Pinecil v2 and updated to firmware 2.23
and it also checks out to be official via the website check.
I bought the Amazon Basics 65W One-Port GaN USB-C PD 3.0
charger which is on the pine64.org list of 20v chargers but it only
goss up to 15v. When I play with the settings I can get it to reach
20v only when PD Mode is set to normal. So the default mode
„no dynamic” as well as „safe mode” only go to 15 volts …
Is that normal?
and it also checks out to be official via the website check.
I bought the Amazon Basics 65W One-Port GaN USB-C PD 3.0
charger which is on the pine64.org list of 20v chargers but it only
goss up to 15v. When I play with the settings I can get it to reach
20v only when PD Mode is set to normal. So the default mode
„no dynamic” as well as „safe mode” only go to 15 volts …
Is that normal?