02-09-2017, 12:27 AM
Hi All,
I have a Pine64 with ZWave module, installed domotizc on it.
I installed open zwave for domoticz.
For it to work, it was needed to create a symlink from /dev/ttyACM0 -> /dev/ttyS2 as domoticz expects to find the open zwave module on /dev/ttyACM0
Now I also have a RFlink, which is connected to the serial port.
And guess what, when I remove the device and symlink, then I see the RFlink getting created as /dev/ttyACM0
Same way, if I keep the symlink, and connect the RFlink, in the log of domoticz I see it complaining about the ZWave device not properly reponding.
I.e. when I connect the RFLink, it will come as /dev/ttyACM0 even if there is already such a device (ore a symlink to it)
Any ideas how to solve it?
Eric
I have a Pine64 with ZWave module, installed domotizc on it.
I installed open zwave for domoticz.
For it to work, it was needed to create a symlink from /dev/ttyACM0 -> /dev/ttyS2 as domoticz expects to find the open zwave module on /dev/ttyACM0
Now I also have a RFlink, which is connected to the serial port.
And guess what, when I remove the device and symlink, then I see the RFlink getting created as /dev/ttyACM0
Same way, if I keep the symlink, and connect the RFlink, in the log of domoticz I see it complaining about the ZWave device not properly reponding.
I.e. when I connect the RFLink, it will come as /dev/ttyACM0 even if there is already such a device (ore a symlink to it)
Any ideas how to solve it?
Eric