Vanilla mainline Debian 11 (Bullseye) on the RockPro64
09-26-2021, 04:02 AM
> The problem was caused by the "HDMI to VGA adapter",
> and connecting it directly to the monitor solved your second report.
> Then just like my case, you also encountered Error: "'grub-install dummy' failed".
I interpreted your report as such, is that correct ?
If so, you should be able to boot from the SD-Card with the same solution as I did.
But, the conditions are as follows
If the above meets your requirements, I can describe how I did it.
----
In the manual partitioning you mention, there are an infinite number of combinations.
Naturally, it is impossible to try every partition.
Therefore, I have only tried the following standard partitioning that seems to be recommended.
Partitioning method:
-- Guided - use entire disk
Select disk to partition:
-- MMC/SD card #1 (mmcblk?) - 15.9 GB SD SC16G
Partitioning scheme:
-- All files in one partition (recommended for new users)
> and connecting it directly to the monitor solved your second report.
> Then just like my case, you also encountered Error: "'grub-install dummy' failed".
I interpreted your report as such, is that correct ?
If so, you should be able to boot from the SD-Card with the same solution as I did.
But, the conditions are as follows
If the above meets your requirements, I can describe how I did it.
----
In the manual partitioning you mention, there are an infinite number of combinations.
Naturally, it is impossible to try every partition.
Therefore, I have only tried the following standard partitioning that seems to be recommended.
Partitioning method:
-- Guided - use entire disk
Select disk to partition:
-- MMC/SD card #1 (mmcblk?) - 15.9 GB SD SC16G
Partitioning scheme:
-- All files in one partition (recommended for new users)