PINE64   ›   Pinecil   ›   General Discussion on Pinecil   ›   Will this power supply work? 4.5mm -> 5.5mm conversion?

Will this power supply work? 4.5mm -> 5.5mm conversion?
TB12GOAT
Pine Initiate
**
Joined: Feb 2022
Posts: 1

Reputation: 0
#1
02-19-2022, 08:06 AM
Hi, hope all is well. 

I have an old laptop charger, 19.5v 3.34A 65W with a broken 4.5mm connector. link

Would there be any issues replacing the broken connector with one of these 5.5mmx2.5mm? link

Thanks!
  Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 3 3,145 05-15-2025, 10:41 AM
Last Post: dreieck
  Pinecil V2 doesn’t power on under any circumstances BigCarrotLeaf 0 875 03-22-2025, 07:29 AM
Last Post: BigCarrotLeaf
Question Pinecil v2 power cycles at higher voltages? clemon79 3 3,828 08-10-2024, 05:47 AM
Last Post: RevAngel
  Connecting a power supply to the Pinecil jon_bondy 1 2,061 02-29-2024, 07:37 PM
Last Post: Okedokey
  Best power supply? naviathan 4 8,633 02-29-2024, 07:33 PM
Last Post: Okedokey
  Asus laptop power supply can also power Pinecil biketool 9 13,349 11-17-2023, 12:57 PM
Last Post: killingmesmalls
  Warning, 5.5mm barrel-style power cables biketool 6 16,500 11-05-2022, 01:47 PM
Last Post: River
  PD-EPR support and power rating over USB Joey_bikefast 1 2,596 11-05-2022, 01:32 PM
Last Post: River
  Pinecil Power Supply with Removable Cables Recommendations moriel5 1 3,708 02-08-2022, 09:50 PM
Last Post: moriel5
  Dead short on the power input of the Pinecil m42uko 7 11,679 04-05-2021, 02:25 PM
Last Post: tllim

Forum Jump:


Users browsing this thread: 1 Guest(s)