I'm in the same boat. I've been trying to work with backerkit, but I'm getting stonewalled with delivered as designed. They're saying the hole is for cable passthrough, but I've pushed back and said that if I wanted a hole I would just get my drill and make my own to fit my cable size (not most of a side of the case). I've also pointed out that if you look at the ABS enclosure right now in the shop, you don't see that it has this huge hole. This feels a lot like a bait and switch.
I went back and dug through my kickstarter updates. It would appear the design changed between January 25th and June 10th. There are a few mentions that they had to reprint all the ABS cases, but supposedly that was due to a minor alignment problem.
I went back and dug through my kickstarter updates. It would appear the design changed between January 25th and June 10th. There are a few mentions that they had to reprint all the ABS cases, but supposedly that was due to a minor alignment problem.
