Chgled Power Reset
#1
Just got my board and was wondering if I can use and exsisting power button and reset button that is already on the enclosure I want to use. There are little holes to put wire through and solder up. Just don't want to mess anything up. I can't find anything to helpful yet. It seems a little to new yet. Under the word Power there is 2 big holes and 2 little holes with a plus in the middle. It is the same under the word Reset as well. There is 2 wires on each button on the enclosure I am using. So it looks like it will work out. Like I said I just want to make sure. Thank you for any help I can get. This is my first post. So I hope I did it right.


Messages In This Thread
Chgled Power Reset - by rduerst - 07-21-2016, 04:55 AM
RE: Chgled Power Reset - by MarkHaysHarris777 - 07-21-2016, 05:29 AM
RE: Chgled Power Reset - by Ghost - 07-21-2016, 06:49 AM
RE: Chgled Power Reset - by rduerst - 07-21-2016, 07:00 AM
RE: Chgled Power Reset - by pfeerick - 07-22-2016, 09:22 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Pine64+ power button PaddyChan 0 1,886 09-14-2020, 09:55 AM
Last Post: PaddyChan
  UK power supply (Pinebook Pro 64) skobi 0 1,713 11-17-2019, 04:55 AM
Last Post: skobi
  Won't power on/boot -- kickstarter A64 2GB fuzzycuffs 3 4,662 02-22-2019, 03:25 AM
Last Post: GaryFunk
  Supply DC power to Pine64 via Pi-2 Connector & Euler Bus? crapped 2 4,013 05-24-2018, 01:58 AM
Last Post: crapped
  short boot time after power-up bongo 7 6,836 10-31-2017, 08:02 AM
Last Post: bongo
  PINE64/ROCK64 infra receiver power on cserem 1 2,676 10-06-2017, 07:25 AM
Last Post: MarkHaysHarris777
  Power supply questions montero65 36 31,395 08-15-2017, 03:51 AM
Last Post: tllim
  Power-on pine by remote kleintvra 1 2,061 08-11-2016, 02:48 PM
Last Post: MarkHaysHarris777
  Pine A64 not powering up / Power button missing vaevictis 10 9,829 07-06-2016, 01:28 PM
Last Post: xalius
  Some hard numbers on Pine64 Power Usage ataylorm 2 6,330 06-27-2016, 06:08 AM
Last Post: ataylorm

Forum Jump:


Users browsing this thread: 1 Guest(s)