PINE64   ›   Pinecil   ›   General Discussion on Pinecil   ›   Dead pinecil

Dead pinecil
Julius_GU
Pine Initiate
**
Joined: Dec 2020
Posts: 8

Reputation: 3
#2
02-09-2021, 12:51 PM
24 volt is fine since it is within the temperature on their website.
I would recommend opening a ticket with the support to get a new one or a refund.
Best Regards, Julius
  Reply


Messages In This Thread
Dead pinecil - by joelspangler - 02-08-2021, 08:26 PM
RE: Dead pinecil - by Julius_GU - 02-09-2021, 12:51 PM
RE: Dead pinecil - by joelspangler - 02-09-2021, 09:16 PM
RE: Dead pinecil - by zer0sig - 02-12-2021, 06:40 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
Question Can Pinecil Read USB-C Cable E-Marker Chips? Garywoo 0 49 04-23-2024, 01:48 PM
Last Post: Garywoo
  Connecting a power supply to the Pinecil jon_bondy 1 399 02-29-2024, 07:37 PM
Last Post: Okedokey
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 2 809 01-31-2024, 12:34 AM
Last Post: suga7
Question Pinecil Tempaerature Reading jumps to Y400°C when active but stays normal when cold H3wastooshort 0 384 12-24-2023, 05:45 PM
Last Post: H3wastooshort
  Asus laptop power supply can also power Pinecil biketool 9 8,335 11-17-2023, 12:57 PM
Last Post: killingmesmalls
  Mass problem Pinecil V2 Harrysteed 0 685 11-02-2023, 09:11 AM
Last Post: Harrysteed
Question Pinecil v2 power cycles at higher voltages? clemon79 2 1,313 10-09-2023, 10:10 PM
Last Post: clemon79
  PD resets during heat up tip [Pinecil V2] Neitron4ik 2 1,573 10-09-2023, 01:22 AM
Last Post: Neitron4ik
  [Hackaday Article] All About USB-C: Pinecil Soldering Iron vajak 1 1,470 02-02-2023, 11:45 AM
Last Post: VaZso
  Brand new Pinecil v2 won't boot on PD jhutch 1 2,274 12-14-2022, 01:03 AM
Last Post: River

Forum Jump:


Users browsing this thread: 2 Guest(s)