08-27-2020, 01:44 PM
simonsouth
Thanks, simonsouth, for your primer. Looking forward to the lengthier version if you ever find time.
I want to boot a efi_stub enabled kernel, and this 2017 u-boot doesn't know the "efidebug" command, which is necessary, according to these instructions. Your tutorial is encouraging enough to proceed to try and build and upgrade u-boot.
Quote:I'll write up a lengthier tutorial when I'm done but to start using the mainline version of U-Boot, assuming you have the prerequisites taken care of (the cross-compilation toolchain installed if needed, the ARM Trusted Firmware BL31 built and the CROSS_COMPILE and BL31 environment variables set appropriately), you'll need to ....
Thanks, simonsouth, for your primer. Looking forward to the lengthier version if you ever find time.
I want to boot a efi_stub enabled kernel, and this 2017 u-boot doesn't know the "efidebug" command, which is necessary, according to these instructions. Your tutorial is encouraging enough to proceed to try and build and upgrade u-boot.