05-27-2020, 03:02 PM
Daniel,
Yesterday on the first of many tests I issued the commands "import wasp" and "wasp.system.run(no_except=False)" Both were accepted without any error messages. After the second command I noticed the Pinetime screen had lit up with the time and date.
The chip in my watch is very easy to read except for the company logo which is partly blurred. it says:
XT25F32BWOIG
1924HTC
E96035
Today I rebooted into the bootloader and then waited a full minute. I then pressed the button once, with no response. A long press after that got me the Pine64 logo by itself, and then a black screen.
I entered the commands you gave me, it failed on "os.mount(flash,'/flash')" with OSError: 1. Attached is the screen from Serial Bluetooth Terminal and a picture of the inside of the watch.
Hugh
Pinetime-log.png (Size: 263.13 KB / Downloads: 720)
inside3.jpg (Size: 314.43 KB / Downloads: 738)
Yesterday on the first of many tests I issued the commands "import wasp" and "wasp.system.run(no_except=False)" Both were accepted without any error messages. After the second command I noticed the Pinetime screen had lit up with the time and date.
The chip in my watch is very easy to read except for the company logo which is partly blurred. it says:
XT25F32BWOIG
1924HTC
E96035
Today I rebooted into the bootloader and then waited a full minute. I then pressed the button once, with no response. A long press after that got me the Pine64 logo by itself, and then a black screen.
I entered the commands you gave me, it failed on "os.mount(flash,'/flash')" with OSError: 1. Attached is the screen from Serial Bluetooth Terminal and a picture of the inside of the watch.
Hugh
Pinetime-log.png (Size: 263.13 KB / Downloads: 720)
inside3.jpg (Size: 314.43 KB / Downloads: 738)