Permanent Watermark?

[Nurb432]

So i finally went ahead and pulled the top of the bezel loose so i could see and get my finger nails in there. It was a plastic sheet as we expected, but there was no way to get to it with the bezel still on ( as i suspected ). Not sure,but the lower part of the bezel may be glued on ? I didnt force it as i had just enough room only removing the 2 screws on top and unsnapping it there. No reason to risk more.

But its off and the print is gone with it.. so that is all that matters

---

That is in fact the screen protector used when the bare screens are shipped to the factory. If you can get a grasp on it, it should be removable.

I do not know if it is possible to remove the bezel without damaging the screen.

Somehow i missed this post, but i did end up getting it off ( see the post above )..

thanks for the help tho