Tutorial[ Seagate Disks ]: Install Seagate OpenSeaChest Utilities

[Neo2018]

Assuming the binaries are ok,
My best bet is that maybe you need to insert the disks in a real Sata port, for example, to enable Power Up in StandBy and SpinUp Control..

I use ROCKPro64 PCI-e to Dual SATA-II Interface Card for HDD disk.
How or where should I do this?

---

1) The compiled Binaries have some problem.
2) The pcie controllers in the middle doesn't let Seagate Firmware Commands pass-trough, and blocks them..
Assuming case 1) its ok..
Going with option
 2) "Pass-Trough"
Probably Pcie controller is blocking the commands that openSeaChest is sending to disks..
Probably it doesn't understand them as they are Seagate Own Command specific, and reject them..

Maybe blocked hdparm, OMV or S.M.A.R.T to?