03-15-2016, 11:27 PM
(03-15-2016, 10:03 PM)SkairkrohBule Wrote:(03-15-2016, 06:59 PM)Hexydes Wrote: I'm also having this problem. I have a Raspberry Pi 2 running without a hitch off of this microusb power supply, but my Pine64 just won't boot. The image looked like it installed to the card just fine, but can't boot at all. Just get a red LED (tried all combinations of peripherals, including none at all).
What is the voltage and amperage of the power supply? How long is the cable? How did you confirm that the image burned correctly?
Charger is listed as 5V 2.4a (total). It has two ports, so I don't know if it's supplying 2.4a when only one is in use or not. Cable is approximately 3ft in length.
Not sure how I would verify that the operating system was written properly. When using the image writer, it looked like it completed without a problem.