(02-02-2017, 10:27 AM)MarkHaysHarris777 Wrote:(02-02-2017, 03:19 AM)mbt28 Wrote: No, It doesnt have a meaning. As far as I know sopine uses ddr3 socket cm ddr2.
However, designing a custom board should be relatively easier with sopine, if I would change one thing I would also put touch, DSI and CSI on module too. This could decrease pin number significantly.
There is not really enough room for that on the sopine card itself. Its really packed with the three main chips and the SD card ...
Would it be possible to make bigger module with same cost included with dsi csi pins on board. Because especially these ports uses so many ports and probably requires more layers. However SD card uses less pins and it could be better if we could have sd pinout on module.