07-22-2016, 09:22 PM
(07-21-2016, 07:00 AM)rduerst Wrote:(07-21-2016, 05:29 AM)MarkHaysHarris777 Wrote: The two-wired switches will work, provided that you connect the correct holes on the board. Double check with the schematics ; there are four holes on the board but only one of them is important connected against one of the other four; if you get it wrong, you won't hurt anything, it just won't work.Awesome. I really appreciate it. Thanks for being so prompt.
marcus
Sent from my SM-G930P using Tapatalk
Yes, the two nearer the edge are the actual switch contacts, the two larger ones further back are the mechanical anchor holes for the switch.
The connections are also repeated on the EXP header - Charger LED is 3, PWR/SB switch is 5, Reset is 4 and GND is 9. Connect PWR to GND to power on / send power off interrupt / force power down. Same goes for Reset - connect to GND for reset.
Connector layout
Connector pinouts