07-21-2016, 06:49 AM
(07-21-2016, 05:29 AM)MarkHaysHarris777 Wrote: The two-wired switches will work, provided that you connect the correct holes on the board. Double check with the schematics ; there are four holes on the board but only one of them is important connected against one of the other four; if you get it wrong, you won't hurt anything, it just won't work.
marcus
If I remember right (someone near the board may want to check), it is the outer two holes on the board for each switch (power, reset) that you want to wire to. The inner two holes of the four are mounting holes, to hold a four-legged style switch in place.