07-21-2016, 04:55 AM
Just got my board and was wondering if I can use and exsisting power button and reset button that is already on the enclosure I want to use. There are little holes to put wire through and solder up. Just don't want to mess anything up. I can't find anything to helpful yet. It seems a little to new yet. Under the word Power there is 2 big holes and 2 little holes with a plus in the middle. It is the same under the word Reset as well. There is 2 wires on each button on the enclosure I am using. So it looks like it will work out. Like I said I just want to make sure. Thank you for any help I can get. This is my first post. So I hope I did it right.