07-16-2024, 12:18 AM
Hi! I have Pine64 SOQUARTZ V1.1, that should run on BTT Manta M8P - for controll 3d printer.
When I upload fresh image on sdcard and boot - all looks fine. After SSH login it begins updates,
then it writes that it should update the kernel and need to reboot, but when go to shutdown nothing happens.
Just overheat and nothing. Even with hard reboot wont boot.
When I upload fresh image on sdcard and boot - all looks fine. After SSH login it begins updates,
then it writes that it should update the kernel and need to reboot, but when go to shutdown nothing happens.
Just overheat and nothing. Even with hard reboot wont boot.