Slarm64 on PinePhone [Unofficial Slackware ARM - 64 bit]

[donchurch]

It turns out that the image that I just documented was for 6.2.5.5 and noticing the 6.5.5 was the latest posted here I just tried it and funny thing is the green light comes on for about 4 seconds then the light goes out and nothing more happens and the serial output is blank.  When I take the card out it boots fine with Maemo.  I didn't think the card could keep the system from going to the main memory for a try.  The fstab now shows the partition ID.  I'll mess with it tomorrow.

  GNU nano 7.2                                                    fstab                                                             
#
# /etc/fstab: static file system information
#
# <file system>        <mount point>  <type>  <options>                        <dump> <pass>
shm                    /dev/shm        tmpfs    defaults                        0      0
devpts                /dev/pts        devpts  noexec,nosuid,gid=tty,mode=0620  0      0
sysfs                  /sys            sysfs    defaults                        0      0
proc                  /proc          proc    defaults                        0      0
#
#/dev/#EXT4FS_BOOT#    /boot          ext4    errors=remount-ro                0      1
#/dev/#SWAP#          swap            swap    defaults                        0      0
#/dev/#EXT4FS_ROOT#    /              ext4    errors=remount-ro                0      1
#/dev/#EXT4FS_HOME#    /home          ext4    defaults                        0      2

UUID=32539e08-a5c0-4084-9f32-0932043d95e3    /          ext4    noatime,nodiratime,data=writeback,errors=remount-ro      0      1