11-03-2023, 02:03 PM
(10-24-2023, 05:00 PM)apink Wrote:Quote:On Sunday 22nd, I did update&&upgrade Mobian on my PinePhone Pro and tried your VoiceCall.conf. Was just loud noise in my case. Tried
cset "name='ADC Capture Volume' 80"
cset "name='Mono ADC Capture Volume' 80"
cset "name='IN1 Boost' 0"
and it was usable.
I had other upgrades since and as a result, today, no sound at all at both sides in a voice call. I rewrote my changes, but still no sound. I am lost.
By the way, is it possible to write alsa options in /etc or in ~/./local (where exactly, under what name?) to avoid loosing improvements on a upgrade?
I remember going through many of these same issues. I now run pmOS edge with the open source modem firmware and have good phone connections. While I don't remember all of the specifics, so I can't help you with your specific VoiceCall.conf settings, I can tell you that there are fairly active discussions in the chat rooms that I have found to be helpful. I have used the matrix channel.
- Discord: channel #pinephone under https://discord.gg/pine64
- Matrix: https://app.element.io/#/room/#pinephone:matrix.org
I like this thread because it is specifically about voice calls with PP Pro. The room #pinephone:matrix is a mess about everything PP and PPP.
I did try again with Volume 80, 80 but Boost 4 and the sound of the call was really good both ways. Next call… no sound at all, both sides. There is obviously a serious problem other than VoiceCall.conf. If pmOS works with some firmware, I really do not understand why other distributions could not do the same. I cannot understand how after many years it is still nearly impossible to use the PP Pro as a phone.
