09-28-2023, 12:15 PM
I tried to continue a few days ago. However, with the worst possible outcome.
In detail: I put the board.itb (in a new subdor of /Boot) and the modules (in /lib).
In the boot.scr, a boot.txt was referenced. So I didn't touch the former and adapted the latter.
Then I rebooted and this is what happened: Nothing
Everything was like before: the"old" kernel continued to run. I gave up for the time being.
A few days later I wanted to continue. But now the PinebookPro no longer boots. After switching on, the LED turns orange and the screen remains dark. I can't quite explain this.
I think that I haven't changed anything again after the first reboot. But maybe I am wring. I will remove the eMMC when I'll find some time. Maybe it can be brought back to life that way. If not, I'll just have to start from scratch.
In detail: I put the board.itb (in a new subdor of /Boot) and the modules (in /lib).
In the boot.scr, a boot.txt was referenced. So I didn't touch the former and adapted the latter.
Then I rebooted and this is what happened: Nothing
Everything was like before: the"old" kernel continued to run. I gave up for the time being.
A few days later I wanted to continue. But now the PinebookPro no longer boots. After switching on, the LED turns orange and the screen remains dark. I can't quite explain this.
I think that I haven't changed anything again after the first reboot. But maybe I am wring. I will remove the eMMC when I'll find some time. Maybe it can be brought back to life that way. If not, I'll just have to start from scratch.
