Armbian and LibreELEC and AltLinux for Quartz64

[balbes150]

@bosi564  I wrote to you about checking the launch of a "clean" Armbian without EDK2. That is, you need to download and burn an image from the directory to the SD card WITHOUT specifying "EDK-EFI" in the directory name. Check the launch of the EDGE and CURRENT versions. And show the UART log when launching the EDGE and CURRENT versions.

For the files:
1. 20221101-current/Armbian_22.11.0-trunk_Quartz64a_jammy_current_5.19.17.img.xz
2. 20221112-edge/Armbian_22.11.0-trunk_Quartz64a_jammy_edge_6.1.0.img.xz

I've downloaded both files. Had to change baud rate to 115200 and 9800 for 1. and 2., otherwise the output on the serial console was all unreadable. Both times the boot didn't reach login shell.

I've attached the logs.

EDIT: seems like the the first log file kernel-5-current-115200baud.log contains logs for kernel version 6.1.0-rc4-media. I'll redo the test and post the log again.

EDIT 2 : I've removed the wrong log file and uploaded the log file 'kernel-5-current-115200.log' for the correct image.

Very strange, by default all RK use 1500000 (in the kernel and u-boot), if you set the wrong values, the output does not work. Judging by the log files, there is no useful data there. How and where is your UART console connected ? Which USB-TTL chip do you use? Have you tried changing the contents of SPI before ? What other Linux versions have you checked before, what does the UART console show with them?