(12-02-2022, 04:22 PM)bosi564 Wrote: My Quartz64 model A finally showed a beautiful bootup picture on my FullHD monitor.1. Try to connect the media with the system to all USB ports.
Nice progress!
Well, for some reason it didn't boot within a minute or so, but I'm tired and will leave it as it is for the night.
I did see the grub menu and after a few log lines showing it's loading the initramfs I got to the three lines with "EFI stub - something" and the third was like "EFI stub: exiting boot services".
As a side note: I tried moving the usb stick to one of the USB 3.0 ports (the bottom right), but GRUB didn't load and I got to see this TianoCore EDK II menu for the first time.
The files I've downloaded are:
1. Armbian_22.11.0-trunk_Quartz64a_sid_edge_6.1.0.img
2. QUARTZ64_EFI.img
written on both a usb stick and sd card as per the instructions on the other forum.
2. Which USB media do you use? I recommend trying the simplest USB 2.0 flash drive.
3. Which devices are connected to USB? Try to disconnect all USB devices at the time of startup, except the USB flash drive with the system, if the system starts, they can then be connected.
4. Try using the Ubuntu variant (Cli or XFCE). I have not tested Debian and there is a possibility of an error in the image.
I found the reason why the Debian image doesn't run. need to manually make changes to the settings. Use Ubuntu image.