12-02-2022, 04:22 PM
My Quartz64 model A finally showed a beautiful bootup picture on my FullHD monitor.
Nice progress!
Well, for some reason it didn't boot within a minute or so, but I'm tired and will leave it as it is for the night.
I did see the grub menu and after a few log lines showing it's loading the initramfs I got to the three lines with "EFI stub - something" and the third was like "EFI stub: exiting boot services".
As a side note: I tried moving the usb stick to one of the USB 3.0 ports (the bottom right), but GRUB didn't load and I got to see this TianoCore EDK II menu for the first time.
The files I've downloaded are:
1. Armbian_22.11.0-trunk_Quartz64a_sid_edge_6.1.0.img
2. QUARTZ64_EFI.img
written on both a usb stick and sd card as per the instructions on the other forum.
Nice progress!
Well, for some reason it didn't boot within a minute or so, but I'm tired and will leave it as it is for the night.
I did see the grub menu and after a few log lines showing it's loading the initramfs I got to the three lines with "EFI stub - something" and the third was like "EFI stub: exiting boot services".
As a side note: I tried moving the usb stick to one of the USB 3.0 ports (the bottom right), but GRUB didn't load and I got to see this TianoCore EDK II menu for the first time.
The files I've downloaded are:
1. Armbian_22.11.0-trunk_Quartz64a_sid_edge_6.1.0.img
2. QUARTZ64_EFI.img
written on both a usb stick and sd card as per the instructions on the other forum.