06-05-2016, 07:37 PM
Hello pfeerick,
thanks for your tips.
In the meantime I got the help from Lukasz in the irc chat, but with the same result.
The uboot was already up-to-date and I posted another log with the most recent kernel,
a few minutes before your post.
About your not to dumb question:
I only (dis)connect the module, if the power cable is detached from the board.
I noticed 2 things about the wifi/bt module:
1. The APX803 gets quite warm, if the wifi/bt module is attached - usaly it stays cold
2. There are some unpopulated smd parts on the wifi/bt module - is this intended?
Thank you,
Christoph
thanks for your tips.
In the meantime I got the help from Lukasz in the irc chat, but with the same result.
The uboot was already up-to-date and I posted another log with the most recent kernel,
a few minutes before your post.
About your not to dumb question:
I only (dis)connect the module, if the power cable is detached from the board.
I noticed 2 things about the wifi/bt module:
1. The APX803 gets quite warm, if the wifi/bt module is attached - usaly it stays cold
2. There are some unpopulated smd parts on the wifi/bt module - is this intended?
Thank you,
Christoph