06-20-2022, 05:36 PM
Hello 
I'm I new owner of a Pinephone. After a few tests I decided to install Mobian Phosh.
To save battery life during the first tests I connected the phone to a power supply (0-30V, 0-5A).
I used a resistence to simulate the battery thermistor.
My power supply is regulated to 4.1V as measured from original battery.
The phone behaviour is very strange to me. Sometimes seem booting but is stuck with black screen, green led in the upper left corner lit and a current drain of 0,4A.
Sometimes it boots and seem to work correctly but if SIM is installed the phone turns off after a few minutes.
Anybody had related experiences or can give me any advice to make it work reliably as with battery?
Thanks and regards
I'm I new owner of a Pinephone. After a few tests I decided to install Mobian Phosh.
To save battery life during the first tests I connected the phone to a power supply (0-30V, 0-5A).
I used a resistence to simulate the battery thermistor.
My power supply is regulated to 4.1V as measured from original battery.
The phone behaviour is very strange to me. Sometimes seem booting but is stuck with black screen, green led in the upper left corner lit and a current drain of 0,4A.
Sometimes it boots and seem to work correctly but if SIM is installed the phone turns off after a few minutes.
Anybody had related experiences or can give me any advice to make it work reliably as with battery?
Thanks and regards
