05-29-2022, 01:34 PM
I have just received a new PinePhone, and the first time I connected it to the Internet, it immediately showed me that (software) updates are available. The phone didn't install the updates before I asked to do so, but still, I was actually quite disappointed with this behavior, especially in a privacy and security oriented phone. I don't want the phone to do anything on the Internet before I explicitly request to do so. Even if it does not install the updates, just checks for them, this still transfers data over the Internet, which may be undesirable in certain cases.
This time I installed the updates (which also created quite a severe bug, see below), but I don't want to have any automatic update checks in the future.
So, my first question is: how do I disable automatic checks for updates on the default OS (if I understand correctly, this is manjaro)?
Second, more details about the bug: sometimes, when I turn off the screen using the button on the side, and then turn on the screen again, instead of a PIN prompt, I see a text message (that does not fit on the screen in full also) and no interface elements at all. I don't know how to continue working with the phone from that point except for removing the battery and inserting it again (which is not good for the OS, I guess).
Some pieces of the message that are visible on the screen:
"... and unlocking is ..."
"... to a virtual ..."
"... and execute the ..."
"... unlock-session ..."
"... session by ..."
"... running session ..."
This time I installed the updates (which also created quite a severe bug, see below), but I don't want to have any automatic update checks in the future.
So, my first question is: how do I disable automatic checks for updates on the default OS (if I understand correctly, this is manjaro)?
Second, more details about the bug: sometimes, when I turn off the screen using the button on the side, and then turn on the screen again, instead of a PIN prompt, I see a text message (that does not fit on the screen in full also) and no interface elements at all. I don't know how to continue working with the phone from that point except for removing the battery and inserting it again (which is not good for the OS, I guess).
Some pieces of the message that are visible on the screen:
"... and unlocking is ..."
"... to a virtual ..."
"... and execute the ..."
"... unlock-session ..."
"... session by ..."
"... running session ..."