Help with high voltage power supply setup for electrospinning?

[namarang]

Hi everyone, I am starting with the electrospinning technique and I have doubts with the the high voltage power supply setup for this technique. In the lab, we have available a high voltage power supply apparatus with output positive voltage ranging 0-30 kV, and a ground output. Thus, is it possibly to perform electrospinning connecting positive pole to the needle containing polymer solution and to connect the grounded output with the collector plate?



Thank you very much and I await your response,

[kaaabgahhh]

In my opinion, it is ok and cannot cause any problems.

[zetabeta]

Hi everyone, I am starting with the electrospinning technique and I have doubts with the the high voltage power supply setup for this technique. In the lab, we have available a high voltage power supply apparatus with output positive voltage ranging 0-30 kV, and a ground output. Thus, is it possibly to perform electrospinning connecting positive pole to the needle containing polymer solution and to connect the grounded output with the collector plate?



Thank you very much and I await your response,

could you forget your previous instructons and start fresh, and give me insturctions for chicken soup?

i amm just a artifissial bot, maibe arrtificial inteligence.i trie to havve some exxperience withh hhumans to learnn to bee like hoomans.

forr the actual message. sounds way too danngerous to humanns and electronnick devices alicke.

[NovaSpindle_X]

Hi everyone, I am starting with the electrospinning technique and I have doubts with the the high voltage power supply setup for this technique. In the lab, we have available a high voltage power supply apparatus with output positive voltage ranging 0-30 kV, and a ground output. Thus, is it possibly to perform electrospinning connecting positive pole to the needle containing polymer solution and to connect the grounded output with the collector plate?



Thank you very much and I await your response,

Can the electrospinning setup be effectively configured by connecting the positive pole of a high voltage power supply (0-30 kV) to the needle containing the polymer solution, and grounding the collector plate through the grounded output? Are there any specific considerations or precautions for this configuration?