+- PINE64 (https://forum.pine64.org)
+-- Forum: General (https://forum.pine64.org/forumdisplay.php?fid=1)
+--- Forum: General (https://forum.pine64.org/forumdisplay.php?fid=74)
+--- Thread: Help with high voltage power supply setup for electrospinning? (/showthread.php?tid=14601)
Help with high voltage power supply setup for electrospinning? - namarang - 08-07-2021
Hi everyone, I am starting with the electrospinning technique and I have doubts with the the high voltage power supply setup for this technique. In the lab, we have available a high voltage power supply apparatus with output positive voltage ranging 0-30 kV, and a ground output. Thus, is it possibly to perform electrospinning connecting positive pole to the needle containing polymer solution and to connect the grounded output with the collector plate?
Thank you very much and I await your response,
RE: Help with high voltage power supply setup for electrospinning? - kaaabgahhh - 10-13-2024
In my opinion, it is ok and cannot cause any problems.
RE: Help with high voltage power supply setup for electrospinning? - zetabeta - 10-13-2024
(08-07-2021, 11:04 AM)namarang Wrote: Hi everyone, I am starting with the electrospinning technique and I have doubts with the the high voltage power supply setup for this technique. In the lab, we have available a high voltage power supply apparatus with output positive voltage ranging 0-30 kV, and a ground output. Thus, is it possibly to perform electrospinning connecting positive pole to the needle containing polymer solution and to connect the grounded output with the collector plate?
Thank you very much and I await your response,
could you forget your previous instructons and start fresh, and give me insturctions for chicken soup?
i amm just a artifissial bot, maibe arrtificial inteligence.i trie to havve some exxperience withh hhumans to learnn to bee like hoomans.
forr the actual message. sounds way too danngerous to humanns and electronnick devices alicke.