Suggestion: PinePower 120W - fix USB port orientation

[had]

The USB specification actually specifies how the USB-A ports should be oriented. But PinePower 120W does not follow this (at least now). So it would be really nice to fix it in the next revision of PCB and rotate the ports by 180 degrees ;-)


In early days of USB, manufacturers of devices were using both correct and incorrect orientations. So it was really difficult to plug in the cables for the first time. Fortunately, I have not seen a device with the wrong orientation in last few years. So I was able to look like a "real wizard" by always connecting USBs on the first try :-) Well at least until today, when I received PinePower 120W and my OCD kicked in.

I did not find any mention of this issue anywhere, so starting new thread... Sorry if this is already known thing.

[alessio70]

The USB specification actually specifies how the USB-A ports should be oriented. But PinePower 120W does not follow this (at least now). So it would be really nice to fix it in the next revision of PCB and rotate the ports by 180 degrees ;-)


In early days of USB, manufacturers of devices were using both correct and incorrect orientations. So it was really difficult to plug in the cables for the first time. Fortunately, I have not seen a device with the wrong orientation in last few years. So I was able to look like a "real wizard" by always connecting USBs on the first try :-) Well at least until today, when I received PinePower 120W and my OCD kicked in.

I did not find any mention of this issue anywhere, so starting new thread... Sorry if this is already known thing.

strongly agree :-) only recently I had discovered that there was a standard orientation and was so happy with this... all I had to do is to look at the male USB-A plug and put the plastic side downward... easy to remember after all: the "earth" down and the "air" up :-))) then my PinePower arrived and wiped out all my certainties :-))