3 hours ago
I have a Rock64 V3 I'm trying to use Klipper/MailSail on to replace a Pi w2 Zero, which has been running my coreXY printer over serial.
I can't seem to figure out the serial connection. I have gotten the Rock64 to run the printer with no problem over USB.
I'm not a strong Linux user, but I managed to make it to the very end here, but I can't get this last part to work.
I feel I'm either missing the correct terms in overlays/ the correct kerral header/ or some permissions or conflict.
I'm trying to use UART2, which are the same pins as the pi w2 zero. 6,8,10
I think I have the serial console disable. I ran:
sudo systemctl mask serial-getty@ttyS2
and see nothing on tty2 now when I run ls /dev/ttyS*
I added to armbianEvn.txt
and added users to the dialout group and confirmed.
I'm not sure about the Kernel header, and one post mentions some jumper pin for the header, but I'm pretty much past the point of my knowledge base, and I'm not sure what to search at this point.
Any direction or information anyone can offer would be appreciated.
I can't seem to figure out the serial connection. I have gotten the Rock64 to run the printer with no problem over USB.
I'm not a strong Linux user, but I managed to make it to the very end here, but I can't get this last part to work.
I feel I'm either missing the correct terms in overlays/ the correct kerral header/ or some permissions or conflict.
I'm trying to use UART2, which are the same pins as the pi w2 zero. 6,8,10
I think I have the serial console disable. I ran:
sudo systemctl mask serial-getty@ttyS2
and see nothing on tty2 now when I run ls /dev/ttyS*
I added to armbianEvn.txt
Code:
overlays=uart1 uart2 uart3and added users to the dialout group and confirmed.
I'm not sure about the Kernel header, and one post mentions some jumper pin for the header, but I'm pretty much past the point of my knowledge base, and I'm not sure what to search at this point.
Any direction or information anyone can offer would be appreciated.
