EXP Reset pin
#1
Does the reset pin on the EXP connector (2x5 pins) need to be high or low to reset the board?
  Reply
#2
According to schematic, it is parallel with the reset switch SW2, and therefore should be bring momentarily to LOW.
  Reply
#3
(05-04-2016, 08:25 PM)martinayotte Wrote: According to schematic, it is parallel with the reset switch SW2, and therefore should be bring momentarily to LOW.

ok. I didnt see that in the schematic, it was just open ended.

thanks
  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)