Pine64 NAS fan problems
#1
Hello all,
I'm new to this forum and hope you guys can help me figure out what I'm doing wrong.

I bought some parts from the Pine64 shop:

- ROCKPro64 4GB Single Board Computer
- Fan for ROCKPro64 Metal Desktop/NAS casing
- ROCKPro64 Metal Desktop/NAS Casing
- ROCKPro64 12V 5A EU POWER SUPPLY
- ROCKPro64 PCI-e to Dual SATA-II Interface Card
- ROCKPro64 20mm Mid Profile Heatsink

I got it all set up pretty quickly thanks to this well done guide here:

https://www.youtube.com/watch?v=_UeeklKo0Og

my only issue is, that the fan won't start spinning when the RockPro boots and I can't figure out why.

Sorry for the Imgur link but the three pictures are too big for the allowed 2.93mb
https://imgur.com/gallery/ax9zBXw

Although I don't think so and the slot says "FAN" right next to it did I plug the fan into the wrong slot?

Any help would be much appreciated
#2
Hi,

this should help you .

https://github.com/tuxd3v/ats#install

Kind Regards
M
#3
(03-30-2019, 10:19 AM)mabs Wrote: Hi,

this should help you .

https://github.com/tuxd3v/ats#install

Kind Regards
M

Hi thank you very much for your answer and your time.

I followed the instructions and was able to configure the profile a little to my needs and it works like a charm.

I may be wrong but where else could I have found these information? Maybe it's worth a comment or two in the "official" NAS case build guide here:

http://wiki.pine64.org/index.php/NASCase

Again thank's a lot for your time. With your help I'm now able to complete my project!
#4
(03-30-2019, 04:10 PM)biomodixHow does your biuld performs? Impressions? Wrote:
(03-30-2019, 10:19 AM)mabs Wrote: Hi,

this should help you .

https://github.com/tuxd3v/ats#install

Kind Regards
M

Hi thank you very much for your answer and your time.

I followed the instructions and was able to configure the profile a little to my needs and it works like a charm.

I may be wrong but where else could I have found these information? Maybe it's worth a comment or two in the "official" NAS case build guide here:

http://wiki.pine64.org/index.php/NASCase

Again thank's a lot for your time. With your help I'm now able to complete my project!
How does your build performs?

Impressions? Speed? Reliability?


Possibly Related Threads…
Thread Author Replies Views Last Post
  Problems with maskrom OTG USB in Linux - Device not responding to setup address nutilius 0 784 08-31-2019, 11:40 AM
Last Post: nutilius
  PCIE SATA controller ASM1062 problems or software vecnar 36 16,784 06-15-2019, 02:35 AM
Last Post: Nikolay_Po
  Any benchmarks for non-pine64 pci to NVMe adapters? crhawle 2 2,310 09-10-2018, 12:47 PM
Last Post: dukla2000
  RockPro64 and PINE64 WIFI Module Compatability sdwhwk 4 3,533 06-09-2018, 04:20 AM
Last Post: pfeerick

Forum Jump:


Users browsing this thread: 1 Guest(s)